99% off The 2021 All-in-One Data Scientist Mega Bundle. 98% off The 2021 Accounting Mastery Bootcamp Bundle. 97% off The Ultimate 2021 White Hat Hacker Certification Bundle.Want to master Microsoft Excel and take your work-from-home job prospects to the next level? Jump-start your career with our Premium A-to-Z Microsoft Excel Training Bundle from the new Gadget Hacks Shop and get lifetime access to more than 40 hours of Basic to Advanced instruction on functions, formula, tools, and more. Wait for my upcoming article on Greebling! It's not always an easy thing to do that without overpainting certain areas, so be careful!Īlso, if you have the time and energy, you may want to do more to the gun than just paint it. They have a lot of little nooks, so make sure you paint it from every conceivable angle in order to get the paint into those crevices. Not so bad for not taking the gun apart, eh? However, I did go over the whole gun and sand away any visible seams and plastic protrusions.Īnyway, here's the "Dart Tag" side after I got done with Dremeling the raised Nerf logo: So in this case, I didn't sand anything other than the parts where I needed to get rid of Nerf logos. First, what parts of the gun do you sand? Usually I recommend sanding anything that you intend to paint, but there are so many textures and nooks on this gun that sanding evenly is nearly impossible. That said, it's not quite as easy as that. Start with a coarser grit, and move to a finer grit in order to get a nice, smooth surface. A Dremel rotating tool will help speed things up, and a power sander will help, too. A few tools will make this job easier for you, but you're probably going to end up doing the fine work with sandpaper, or a sanding block. This stage will take a long time, so you'd better be prepared to put some elbow grease into it. Yeah, you heard me: sand the crap out of it. "Don't point this gun at anyone's eyes, keep it away from your genitals, etc." What was particularly difficult about it was that that whole section is lowered, making it hard to get a smooth, continuous surface across that side of the barrel.Īnyway, our next step will deal with all of that: Step 2: Sand the Crap Out of It It's hard to see because it doesn't really stand out (it's green-on-green), but on the right side of the above picture is a whole bunch of safety text. You can still see the price tag on it in the picture below! I picked this gun up at the thrift store for 99 cents. Step 1: Get Yourself a Nerf Gun (or Buzzbee, If You're Desperate) It's blue, and you'll see it used extensively in this tutorial. The only thing you need for this tutorial is whatever color spray paint you intend to use, and some painter's tape! As far as tape is concerned, I recommend the Scotch "Easy Release" Painter's Tape. So instead, I'm going to show you how to paint a Nerf gun without taking it apart. I understand that there's some form of skill to it, but it may as well be rocket science to me. Well, I'm glad that some people can do that, but let me tell you something: I have never been able to put a Nerf gun back together once I've taken it apart, and then had it still work. Steampunking Nerf guns by painting them is a pretty common practice among Steampunks, but unfortunately, the really amazing-looking ones involve literally taking the gun apart, painting it, and then screwing it all back together.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |